FTM 166: What do you do when a customer rejects a product?

This edition of the Fastener Training Minute with Carmen Vertullo was originally published July 17, 2021 as “What do you do when a customer rejects a product based on a requirement, that was not part of the original specification? ” during episode 166 of Fully Threaded Radio. Well hello everyone, This is Carmen Vertullo with […]

Continue Reading…

FTM 154: ASME B18.16.6 nylon insert lock nuts

This edition of the Fastener Training Minute with Carmen Vertullo was originally published July 21, 2020 as “ASME B18.16.6 nylon insert lock nuts” during episode 154 of Fully Threaded Radio. Today’s topic, like many of our topics came via an email question. Actually, it was a problem that a client had regarding the proper designation […]

Continue Reading…

FTM 112: The Wedge Tensile Test

This edition of the Fastener Training Minute with Carmen Vertullo was originally published January 12, 2017 as “The Wedge Tensile Test” during episode 112 of Fully Threaded Radio. Well, hello everyone, this is Carmen Vertullo with your Fastener Training Minute from the Fastener Training Institute and the Carver FACT Center here in El Cajon, California. […]

Continue Reading…

FTM 108: What to do with Nicked Threads

This edition of the Fastener Training Minute with Carmen Vertullo was originally published September 22, 2016 as “What to do with nicked threads” during episode 108 of Fully Threaded Radio. Well, hi everybody, this is Carmen Vertullo with the Fastener Training Minute coming to from the Carver FACT Center in El Cajon, that’s Fastener Applications […]

Continue Reading…

FTM 106: How do I measure the external thread minor diameter

This edition of the Fastener Training Minute with Carmen Vertullo was originally published June 20, 2016 as “How do I measure the external thread minor diameter?” during episode 106 of Fully Threaded Radio. Well, hi everybody, it’s Carmen Vertullo with your Fastener Training Minute coming to you from the Carver FACT Center here in San […]

Continue Reading…

FTM 100: My Tri-Roll gauge rejects a thread the supplier says is OK

This edition of the Fastener Training Minute with Carmen Vertullo was originally published December 16, 2015 as “A question about thread acceptability” during episode 100 of Fully Threaded Radio. Hi everybody. This is Carmen Vertullo from Carver Consulting and the Fastener Training Institute with the Fastener Training Minute. Today I went deep into the archives […]

Continue Reading…