Tag: Industrial Fasteners Institute

FTM 100: My Tri-Roll gauge rejects a thread the supplier says is OK

Posted on by Brian Musker
Fastener Training Minute 100: My Tri-Roll gauge rejects a thread but the supplier says it is OK

This edition of the Fastener Training Minute with Carmen Vertullo was originally published December 16, 2015 as “A question about thread acceptability” during episode 100 of Fully Threaded Radio. Hi everybody. This is Carmen Vertullo from Carver Consulting and the Fastener Training Institute with the Fastener Training Minute. Today I went deep into the archives […]

Read More… from FTM 100: My Tri-Roll gauge rejects a thread the supplier says is OK

FTM 99: Where should I NOT use socket set screws?

Posted on by Brian Musker
Fastener Training Minute 99: Where should I not user socket set screws

This edition of the Fastener Training Minute with Carmen Vertullo was originally published November 19, 2015 as “another war Story about socket set screws” during episode 99 of Fully Threaded Radio. Hi, everybody, this is Carmen Vertullo with the Fastener Training Minute brought to you by Fastener Training Institute and Carver Consulting. If you’ve been […]

Read More… from FTM 99: Where should I NOT use socket set screws?