FTM 110: Correctly Handling a Reject

This edition of the Fastener Training Minute with Carmen Vertullo was originally published November 4, 2016 as “How to handle a Reject” during episode 110 of Fully Threaded Radio. Hi everybody, thank you for listening to the Fastener Training Minute coming to you from the Carver FACT Center here in beautiful San Diego California. From […]

Read More… from FTM 110: Correctly Handling a Reject

FTM 100: My Tri-Roll gauge rejects a thread the supplier says is OK

Fastener Training Minute 100: My Tri-Roll gauge rejects a thread but the supplier says it is OK

This edition of the Fastener Training Minute with Carmen Vertullo was originally published December 16, 2015 as “A question about thread acceptability” during episode 100 of Fully Threaded Radio. Hi everybody. This is Carmen Vertullo from Carver Consulting and the Fastener Training Institute with the Fastener Training Minute. Today I went deep into the archives […]

Read More… from FTM 100: My Tri-Roll gauge rejects a thread the supplier says is OK